Wood panels

Google translate

English Danish Estonian French German Polish Russian Spanish Swedish

Wood panels

Installation instructions • Wood panels

Read the instructions carefully before installing the panels!


Before installation

• NB: The panels are only for indoor use and they cannot be in direct contact with water.
• Any defects in the goods can be referred to only before installing them!
• Make large surfaces out of the same production lot.
• The temperature and humidity of the room need to be normal. The room temperature has to be approx. 20°C and the RH of the room approx. 40%. It means that the walls and ceiling of the room needs to be dry and the windows and doors have glasses.
• The panels should not be exposed to over 110°C of continuous heat.
• The temperature and humidity of the panels should be stabilized to the same temperature and humidity than the one in the installation environment, approx. 3 days before attachment. You do not need to open the whole packages, make a hole to the end of the packages, from where the possible humidity can be removed.


• The distance between the joists should be about 400 mm or less, so the roof does not begin to "slouch".
The thickness of the joists 45x45 mm (min 20x40 mm).
• Ensure adequate air circulation behind the panels. If necessary, remove the bottom panels or attach reverse panels.
• Make sure that the bottom panels are straight, even if the ceiling is uneven.


• We recommend that you install the panels by using a stapling gun that is operated by compressed air.
• TShoot the staple diagonally into the long, protruding lower lip of the groove.
• Leave at 10-15 mm expansion gap between wall and the panels. The joint will be covered with fold molding /cornice.


•  Lights or heavy objects must not be attached to the panel, they need to be attached directly to the joists.